Order EMD springs and EMD spacers together and the entire order ships free anywhere in the lower 48.
For a more aggressive stance on the factory 20 inch wheels, this flush kit gets the G80 M3 and G82 M4 sitting where they should. The kit includes two 12.5mm front spacers, two 15mm rear spacers and twenty extended wheel bolts.
The spacers are machined from 6061-T6 aluminum and black anodized for corrosion resistance, with slots cut into the back face so they pull off the hub cleanly instead of seizing on.
Bolts are genuine European spec, zinc plated with a ball seat radius for OE type wheels. Cheap bolts fail over time and there is no good reason to save a few dollars on the fastener holding your wheel to the car.
Center bore 66.56mm. Bolt pattern 5x112. Bolt spec 14x1.25 conical. Recommended for use with the factory 20 inch wheels.
If the vehicle is lowered, rear camber must be adjusted to approximately -2.3 to avoid rubbing. No adjustment is needed at factory ride height.
Please note that spacers are non-returnable once fitted to a vehicle.
FITMENT
- G80 M3
- G82 / G83 M4
